After my last guitar build I realized that I would need to make more jigs. Since I have rough cut a few necks I decided to start making neck jigs. The first of these is a jig for routing the joint where the neck meets the guitar body. Usually with a dovetail or bolt on configuration.
I used a single piece of MDF (2’x4′) to make this whole jig (and still had some left over.) However if I had to do this over again I would have used plywood. The MDF tends to not hold up when you take thickness out of it as I have done here. So I will likely be making another one of these in the future.
Previously I had purchased some neck routing templates and made this jig to accommodate those templates. They just slide into the slot I made and bolt in place for routing. I have not yet tried this jig because I need to find the right bolts to use, but I have high hopes that it will work fine.
If you want more specifics on how I built this just comment and I can help you out.
As a side note: I’ve realized a better way to cut guitar necks and am at a stand still with the current six necks I cut. While I’m hoping I can salvage the six I cut, I am also not kidding myself that they may all end up scrap. Bummer.